Havis Shields Automobile C VS 1200 EXPL User Manual

INSTALL INSTRUCTIONS C-VS-1200-EXPL

2002-2005 FORD EXPLORER

TOOLS REQUIRED:

Metric Socket Set

Ratchet Wrench

Phillips Screw Driver

Panel Pulling Tool

INSTALLATION:

1. Remove O.E.M. Console

7mm Screw

• Remove the one 7mm Hex head screw located in the

accessory pocket of the O.E.M. Console:

• Un-plugged the factory 12volt outlet in order to

completely remove “FACE” of O.E.M. console.

• Remove top “FACE” of O.E.M console. After Hex

head screw is removed, simply pull straight up on

“FACE” in the rear and then pull back to release the

front of the console.

• Remove (2) 7mm hex head screws that attach the

lower portion of the OEM console housing located under the HVAC controls.

• Remove (6) more 7mm screws located under the “Face” of the OEM console.

• Save all removed hardware, this will be used later to install the VS console.

• If equipped with the Traction control switch option, unplug and remove from OEM

console.

2. Install Explorer VS-Console:

• Place VS-Console where the “FACE” of the O.E.M console

was originally located.

• Mount VS-Console using the (6) 7mm screws (removed

earlier).

• If necessary, install traction control switch into the supplied

plate.

Mounting

Hardware

7mm Hex

head screws

“FACE

C-VS-1200-EXPL-INST-8-05